Installing Pine Wood For Tongue And Groove Wood Ceiling
Installing Pine Wood For Tongue And Groove Wood Ceiling – A pine ceiling is an interesting variation on typical drywall, drop ceilings, giving a warm, country look to a room. Modern ceiling boards are designing with light wood (pine is typical). With boards that fit into a tongue & groove system, such as a wooden floor. Be sure to get pre-finished boards. Or do away with them yourself before installation.
The first to installing tongue and groove wood ceiling is finding and mark each with an electronic stud finder. Have each line for each joist cross the entire ceiling. Measure the length of the initial side of the roof then cut a pine ceiling tile to this length. Lift the ceiling board alongside the match with the grooved side of the timber facing the wall. And positioned at ½ inch outside. Shoot two nails through the face of the board at each point where you cross a beam.
12 Photos Gallery of: Installing Pine Wood For Tongue And Groove Wood Ceiling
Measure and cut the next council to installing tongue and groove wood ceiling. Lock the groove of the plate near the edge of the tongue of the first plate and press it firmly into place. The second plaque in place of the nail by throwing a nail from the side next to the tongue at an upward angle in joist. Place one nail per beam on the other side. Repeat the process to install the rest of the cards. Install them all, shooting nails through the sides. Cover the entire ceiling. The final panel along its length, with a saw table, leaves a ½-inch gap in the wall of the last and fix it preaching face-like you did in the first. Install the trim around the perimeter of the ceiling, cut it in your miter saw and securing it with the preacher, and then cover the gaps by wooden walls.More reader came from this term: tongue groove wood ceilings installation